N69 - Atlantic
Wall Hung Bathroom Vanity

N69 Atlantic washbasin bathroom vanity unit, 45cm in depth, with shaped mirror and 2 vertical column cabinets.

* Required Fields


From €2,333.34
Wishlist

Description

N69 Atlantic is a washbasin bathroom unit which is 45cm in depth and features a shaped mirror and column cupboard with 2 doors. The suspended base section which holds the basin is equipped with a deep metal drawer. The base sections on either side feature 1 hinged door each and an internal glass shelf. The HPL top is particularly scratch-resistant, wear-resistant, heat-resistant and hygienic. The minimal mineralguss basin is very practical, thanks to its ability to withstand high temperatures. The top does not feature a tap mixer hole, as the tap is to be positioned on the wall - a modern solution for a clean design.
The space-saving column cupboard with two doors, only 20.8cm thick, allows you to make the most of the space available to you.

Characteristics
reduced depth for increased practicality
large octagonal bathroom mirror of 120cm with LED backlighting
suspended column cupboard: additional space for storing bathroom products or towels
suspended unit for long and slim bathrooms
top in HPL is hygienic thanks to the non-porous surface which stops dirt from getting in

Materials and Finishes
Base sections and column cupboard:
- melamine
- lacquer: matt, glossy, on melamine, on wood
- wood veneer
Top:
- stratified HPL

Purchase Information
Tap is not included; you can, however, purchase the Universal Siphon. The basin is equipped with a drain valve without plug.

Technical study

Technical Specifications and Equipment
The N69 bathroom unit is composed of:
n.1 suspended washbasin section with deep drawer, cm 70 d.45 h.50.
n.2 suspended base sections with door, cm 35 d.45 h.50. One section will open to the right, the other to the left.
n.1 top in stratified HPL, cm 142,4 d.46, 1cm thick. The top is not equipped with a mixer hole; instead we recommend a mixer hole which is positioned on the wall.
n.1 built-in, countertop washbasin in mineralguss, mod. Paola, cm 60 d.34,5 h.16,5 (the washbasin protrudes 5cm above the top). The measurements of the basin itself are: cm 59,5 d.33,5 h.13. It is equipped with a drain valve (without plug), but not with an overflow hole.
n.1 suspended column cupboard with 2 doors, cm 70 d.20,8 h.150, complete with 3 internal glass shelves, 6mm thick, with plastic supports. The handles are mounted on the upper part of the door while the recess grip is vertical.
n.1 mirror, mod. Borea, cm 120 h.75, 3cm thick, complete with flexible LED strip, mod. Strip cm 345 (waterproof, 9.6W per metre, 4000 K) and with a power supply of 50W. The mirror is not equipped with a socket and switch module.

Base and column cupboard structure: 1.8cm thick, composed of particle wood panels. Handles of choice, as well as the push-pull system and recess grips.
Doors: equipped with hinges featuring an integrated decelerating system, which closes the doors slowly and without making any noise.
Drawer: shaped in such a way so as to allow space for the drains, equipped with a Legrabox metal frame, characterised by its straight sides both internally and externally, only 1,28 cm thick.
Handles: è various models to choose from, as well as the push-pull system.
The cod.152, cod.16 and groove handles with grip are available in a matt lacquer finish in all the colours in the material samples.
The recess grip handles are only available with melamine or lacquer finishes. The groove handles are only available with wood finishes (expect 306 Smoky Walnut) and lacquer finishes.
The mod. 68 handles protrude by 4 cm from the surface of the door.

Maintenance Tips
Melamine: simply use neutral liquid detergents to clean. To get rid of limescale stains clean with anti-limescale or a vinegar soaked sponge, then rinse and dry. Do not use acid, abrasive powder or products; do not leave anti-limescale products on the top for long, as they may leave rings.
Lacquer: use a soft and not abrasive rag to avoid damaging the surface. Do not use products with solvent, acetone and abrasive, or wax, alcohol and silicone-based products.
Wood: “living” material with protective painted cover; use a soft, not abrasive and slightly dump rag to clean. It is recommended to clean following the wood grain and then dry with care.

Further Information...
Mineralguss: è material composed of calcium carbonate and aluminium trihydrate, bonded by a low percentage of polyester resin. The gelcoat film that covers the surface guarantees an excellent physical and chemical resistance. This compound is a ductile material, resistant to heat. Possible colour variations, caused by high temperatures, can be removed by cleaning with a slightly abrasive sponge, and polishing afterwards.
Clean with a sponge and a standard cream detergent. The top surface must not come in contact with solvents and alkaline lotions such as ammonia. Hair dyes mustn't be left in the sink for too long, but rinsed immediately. Never fill the basin with water hotter than 60°C.
Stratified HPL: laminated HPL, 10mm thick, made up of layers of cellulosic fibres impregnated with phenolic resin. The external layers, however, are impregnated with thermosetting resins. The material is subjected to polycondensation of the resins with a combination of strong pressure and heat of 150°. The surface is then rough to the touch. The material has many properties which are necessary for settings where there is a need for a high level of hygiene. It is a non-porous material which does not generate mould or the growth of bacteria. It is resistant to scratches, bumps and general wear. It is characterised by its capacity to endure chemicals, organic agents, and for its high level of impermeability. It is dust-proof, easy to clean, non-toxic and suitable for contact with food, environmentally friendly, heat-resistant up to 170° and non-flammable.

Video

Additional Information

Area of Production
Italy
Assembling
Medium Assembling
Assembling Instructions
See Video Tab
Cubic Metres
0,66 m³
Other Products from the same Collection
View all the products of the collection (cod.cmp)

Partner Factory

This bathroom furniture is a 100% Italian product made by a company from the province of Pordenone that started in the field during the 90s. Initially oriented towards the production of classic and modern bathrooms, it grew throughout the years earning national and international fame in the water and sanitary system as well. The company headquarters cover 16.500 square metres and are equipped with innovative machinery. Its business is characterised by the high quality standard of the materials employed, studied and renovated every year to follow the latest fashion. The solid wood comes from forests that follow regularised policies regarding tree cutting and all the other materials are either recycled or recyclable. Every productive phase takes place inside the company itself in order to guarantee the highest monitoring level.

The company creates its personal models but still focuses on the needs of modern housings in terms of space and taste. Moreover, the modular nature of the products allows for high customisable projects. It is possible to widen the initial composition with additional accessories and equipment in every moment. The wide collection and the colour range offered cover several different styles and types of environment: from a more elegant and refined bathroom to an original design, from soft and natural shades to pastel colours. Cabinets with drawers and baskets placed under the basin, wall-hung drawers, columns to store linen or beauty products, dressing tables of the most diverse shapes: the bathroom vanities of this collection are thought to satisfy every need.

Bathroom Furniture

You may also like