The customisations that can be purchased in this product sheet allow the reduction in width and depth of the sliding, door and coplanar wardrobes of the Lounge collection and more specifically:
- width reduction involves cutting the top, back, doors, shelves, bottom and, where provided, hanging rods
- depth reduction involves cutting the top, bottom, sides and shelves
The customised height, however, can be configured directly in the individual wardrobe product page.
Purchase Information - Width Reduction
The reduction is only available on Rover and Nadir models, in all heights. It is therefore not possible to reduce the width of wardrobes in the Comet and Deneb collections.
In the models with reduced width it is not possible to add pull-out accessories and glass shelves with metal frames. The same accessories are not available in the modules adjacent to the reduced width module if the reduction no longer permits a total overlap of the doors.
Example: If in a wardrobe of two 93,5 cm modules, only one of the two was reduced to 90 cm, the total overlap of the open doors would no longer be possible. Consequently, neither of the two modules that make up the wardrobe could be equipped with drawers or pull-out accessories.
N.B. Keep in mind, when specifying the desired width, that 4 cm of free wall space is required to ensure proper assembly of the wardrobe.
Purchase Information - Riduzione in Profondità
In contrast to the width reduction, all Lounge sliding models, including Comet and Deneb, can be reduced in depth.
In depth-reduced wardrobes, it is not possible to add pull-out accessories and glass shelves with a metal frame.
N.B. The minimum achievable depth, including door thickness, is 32,4 cm for the Rover and Nadir collections, 34,8 cm for the Comet collection with doors and 29,7 cm for the Deneb coplanar collection
